QUESTION: Will it fit on my old Sears Craftsman Tablesaw?

ANSWER: YES! A large percentage, almost half, of the Fence Systems we sell are installed on these saws! Installing an ACCUSQUARE FENCE will give you the precision and reliability you are looking for!

QUESTION: I have an out feed table at the rear of my saw. Can your fence be used without the back rail?

ANSWER: Yes. As with most front locking fences the fence can be used without a back rail and the saws top can be used to support the back of the fence.

QUESTION: My old Beaver Rockwell has a projection on the front and rear edge of the top. Can your fence system be installed on this old saw?

ANSWER: We have a set of adapters available at no charge. These will allow for easy installation of the Accusquare fence on your saw. In addition, these adapters allow for installation on a wide variety of saws that have thinner tabletops or saws with irregular front edges such as Ryobi or Hitachi.

QUESTION: I have a Shopsmith. Will your fence fit?

ANSWER: Yes the fence will fit your Skopsmith. The only problem is the ability to remove the fence quickly to set up other operations. We have available a special set of adapters that allow for quick on and off. These are ideal for Shopsmith owners and for other saws or band saws that have a need for quick removal of the fence system. A set of adapters is available for $9.99 US or $14.00 CDN.

QUESTION: I need a better fence system for my Laguna 16”, one that I can add a wide face board to for sawing wider boards. Can your fence your fence fit and will it accept facer boards?

ANSWER: This is the type of saw that our fence was developed for. Don’t let the fact that it fits smaller saws or is priced less than most other band saw fences distract you. The T-Slots, that most other fences do not have, allow you to add facer boards to firmly support wider stock when re-sawing.

QUESTION: I have a General cabinet type saw. Will your sliding table fit?

ANSWER: Yes. Our sliding table will fit all contractor and cabinet type saws. On some cabinet saws the wheel on the left hand side gets in the way of our support bracket. We have an extension available, at no charge, to accommodate this situation.

QUESTION: How is the router table attached to the saw?

ANSWER: The router table is held on by the rip fence rails and can also be attached to the side of the saw top if the extension wing is removed.

QUESTION: What holds the router fence in place?

ANSWER: The router fence is held in place by the T-Slots on the Accusquare fence system. The fence is held in place by the side T-Slot and the dust collection plate is held in place by the top T-Slot.

QUESTION: Your router plate is small. How can it be used with a large router?

ANSWER: Most router plates were designed before the advent of the 3 ¼ HP routers. To prevent sagging and bouncing during router operations, we designed the smallest plate possible. To remove our router plate the router is lifted slightly and tipped out the bottom of the table.

QUESTION: If I get your fence system, and in the future I get a new saw, can I remount your fence?

ANSWER: Yes.
And to help you celebrate your new saw we will provide you with a new tape at no charge.

Still have a question? Click here